Place the sticky side of the clear layer down onto the fabric.Use tweezers to replace any that have moved out of place. Check design to make sure that the rhinestones have not moved.Slowly and carefully peel away the white layer from the clear layer.If this is the case, cut out the specific rhinestone design. More than one rhinestone design may be on the transfer paper.It is plastic and keeps the sticky side of the clear layer from coming in contact with unwanted surfaces until you are ready to apply the transfer.
The white layer is the bottom of the transfer. It is heat resistant and the rhinestones are held in place by its sticky side. The clear layer is the top of the transfer.
The rhinestone design is “sandwiched” between 2 layers of paper a clear layer and a white layer.It may also help prevent the "impression" of the design from showing through to the other side of the garment. If your garment is sheer/thin, place a piece of parchment paper or Teflon sheet inside the garment so that the rhinestones do not stick through to the other layer. Lay the garment on the heat press table.
The bottom of the heat press should have a 1/4” silicone pad so that the pressure is distributed evenly over the entire transfer.
0 kommentar(er)
